SYEMB06 Installation Guide for SY85

Introduction:

Static Electricity Precautions
Before handling any type of electronic PCB you must be aware of the dangers of static electricity.
Static electricity builds up in your body when you walk around on carpet and other flooring materials. Your clothing generates static when you move about. When you remove certain types of clothing you hear ‘clicking’ or even see sparks in a darkened room – that’s static electricity!

Although static is harmless to humans it is VERY BAD for electronic components – if it jumps from you to any electronic PCB you will surely cause damage to the electronic components mounted on it.

To eliminate static electricity problems we recommend you use an anti-static wrist strap.
This will look something like the photo below:


The cloth loop goes around your wrist and the crocodile clip connects to the nearest earthing point. Earthing points you can use are the outside of your PC’s metal case, water pipes, or any other electrical appliance casing that you know is earthed.

If you don’t have an anti-static strap you can discharge static from your body by touching any earthed case or water pipe before handing anything electronic. Try not to move around too much and keep touching the earthing point from time to time.


Installing the SYEMB06

The module will come supplied in a static shield bag. This bag keeps the module safe from static harm but is vunerable once it leaves the bag. Do not touch any of the components on the board and try to hold the board by the edges only.

Before installing a module in your Yamaha unit please backup the internal memory. After a module is installed you will need to initialize the sample memory and this may initialize the patches. It is highly recommended to backup all your settings and patches before proceeding!

To backup your unit’s settings and patches over MIDI please use the C6 Utility availiable for free from Elekton’s website (ZIP File).


STEP 1: Remove the expansion cover.
Using a Philips or ‘starhead’ screwdriver remove all 6 screws from the cover.


This will reveal the memory expansion connectors. In the photo below the Non-Volatile connectors are arrowed on the left, and the Volatile SIMM connectors are on the right. In this SY85 there are two 4MB SIMMS already installed thanks to Saul from Yamaha-Musicians 🙂



STEP 2: Note orientation of the connectors.
The Non-Volatile connectors on the motherboard are a ‘D’ shape and this ensures the memory modules will only fit in the correct way around.
Note the two arrows pointing to the PCB markings (1) and (2)
If you are installing a single module you must locate it in Connector 1 – it will not work in Connector 2.



STEP 3: Inserting a module (or two)


Place the module’s connector over motherboard Connector (1) and with a finger either side of the module’s edge gently push the module fully into the motherboard connector.


If you are installing two modules place the second module over connector (2) and push it gently into the connector.


When viewed from the other side of the connector panel the SYEMB06 modules and SIMMS will look like this:


Now replace the panel cover and the 6 screws – the installation procedure is finished!

// Document End

sector101

Leave a Reply

Your email address will not be published. Required fields are marked *